6 Common Electrical Problems
Electrical failures can cause more than frustration – they can cause serious damage to your wiring and even an electrical fire hazard. Assessing the source of the electrical failure is crucial, and once you've identified the root of the problem, consider reaching out to a reputable South Plainfield electrician so that electrical repairs can be made as soon as possible. Electrical failures are common, and you may have to spend some time troubleshooting before recognizing the cause of the complication.
Overlamping
Overlamping occurs when a light fixture possesses a light bulb that has a higher wattage than the fixture was meant to handle. This error may result from old wiring. If overlamping occurs, the socket can heat up, and the wires can melt, leading to damage of the fixture and the potential for an electrical fire.
Burned Outlets
The wire insulation may be melted if an outlet pops and sparks when you insert a plug into an outlet. After the spark, a flare can burn out the outlet and cause blackening around the plugs. You should stop using this outlet immediately and contact your electrician promptly so that an electrical fire does not cause further damage.
Aluminum Wiring
In the past, aluminum served as an inexpensive substitute for copper wiring, but aluminum is no longer safe because of its tendency to corrode when connections loosen and when it comes into contact with copper. To correct this problem in your light fixtures, your electrician can retrofit a dielectric wire nut for aluminum wire to copper connection. The grease in the nuts should cease the corrosion of aluminum.
Tripped Circuit Breaker
When your circuit breaker trips, your outlets can stop working. This problem can occur because you are overloading the circuit with too many devices or the knob on the breaker is stuck in the middle of “on” and “off.” You can reset breakers on the panel that are turned off.
Switched PlugsIf the builder of your home installed a switch that manages only half of the outlets in a room, you will have to identify all of the home's switches and their functions. Builders wire houses in this way so that homeowners do not have to walk over to a lamp to turn it on. They can simply flip a switch.
Backstabbed Wiring
Backstabbed wiring occurs when wires have been pushed into connectors that grip the wires inside electrical devices and appliances. Backstabbed wires create a loose connection, resulting in burned out wires and a dead circuit.
If you experience electrical complications, contacting an experienced South Plainfield electrician like One Call Electrical, Heating & Cooling Service, Inc is a wise decision. Specialists will discover the cause of your wiring problem and will repair damage to prevent any further harm of your wiring and devices.
